Activeforever Spa2Go Portable Spa (Blue) - Manual (Page 2)

Plug GFCI back into a grounded outlet. Never
use an extension cord
Reset your temperature back to 104 degrees
Now you will test for warm water flow. Place your
finger directly over the lower water inlet valve and
hold that position for 10-15 seconds. Slowly move
your finger away. You should feel a short burst of
warm water. If there is warm water, you have
successfully removed any debris and your spa
should now heat to the desired temperature.
Replace the donut or bagel shaped top
and the cover and secure using the clips.
Let run until the water temperature
reaches the desired setting.
www.Activeforever.com