Part 3: “wiggle” test, Sometimes called “continuous monitor” test.) – Actron Ford Code Scanner CP9015 User Manual

Page 37

Advertising
background image

37

Part 3: “Wiggle” Test

(Sometimes called “Continuous Monitor” test.)

• This test can help locate intermittent

faults in SOME circuits (see chart on
page 36).

• When Wiggle test is activated, the

Code Scanner STO light and Audio
tone will turn on if a problem is
detected.

• The STO light and tone are only

energized as long as the fault is
present. If the problem goes away,
the light and tone will turn off.

• If the STO light and tone come on as

you wiggle a sensor, connector or
wiring, that’s where the problem is!

1) Safety First!

• Set the parking brake.

• Put shift lever in PARK (automatic

transmission) or NEUTRAL (manual
transmission).

• Block the drive wheels.

2) Make Sure

Ignition Key
is in OFF
Position

3) Check Code Scanner Battery

• Refer to Section 2.

4) Connect Code Scanner

• Refer to Section 3.

• Plug BOTH test connectors into the

Code Scanner!

5) Put HOLD/TEST Switch in HOLD

Position

6) Put AUDIO Switch in ON Position

7) Turn Ignition Key to ON Position

but DO NOT START ENGINE

8) Depending upon Vehicle Model

Year....

• 1986 & Older: “Wiggle Test” is now

activated! Go to Step 9.

• 1987 & Newer:

—Without pausing, move HOLD/
TEST switch to TEST then to
HOLD and then back to TEST.

—“Wiggle Test” is now activated!
Go to Step 9.

9) Perform “Wiggle Test” on

Suspected Circuit

• Lightly tap sensor.

• Wiggle sensor connector.

• Twist and shake wiring between

sensor and computer.

• If the above

actions recreate
an intermittent
fault, the STO
light will light
and a tone will
sound for as
long as the fault
is present. This
can help locate the area of an
intermittent problem!

NOTE: If a fault is recreated this way,
a service code will be stored in
computer memory. Be sure to erase
this code from memory after making
all repairs. Refer to Section 4 (Self-
Test Part 5: Erasing “Continuous
Memory” codes).

10) Move Switches:

• HOLD/TEST switch to HOLD.

• AUDIO switch to OFF.

11) Turn Ignition Key to Off Position

12) Disconnect Code Scanner

T

M

TEST

HOLD

CP 9015 - Ford, Lincoln & Merc

ury

AUDIO

ON

OFF

Advertising