Actron Ford Code Scanner CP9015 - Manual (Page 43)

43
Self-Test Part 2:
Key On Engine Off (KOEO) Self-Test.
IMPORTANT: You must complete all steps in Self-Test Part 1
before proceeding to Part 2.
1) Verify:
Ignition Key is in OFF Position and
Code Scanner is Connected.
2) Put Code Scanner HOLD/TEST
Switch in TEST Position.
• Optional: Turn the AUDIO switch ON to
hear “beeps” when the codes are sent.
3) Turn Ignition Key to ON Position but
DO NOT START THE ENGINE.
• This starts the KOEO Self-Test.
• Codes are sent after 5 seconds.
• Pay no attention to a brief blink which
may occur after ignition key is turned
to ON position.
4) Get Codes from the Flashing STO
Light.
Note: If the light does not flash, go
back and repeat SELF-TEST PART 2
starting with Step 1.
If the light still does not flash, you have
a problem which must be repaired
before proceeding. Refer to the vehicle
service manual “Self-Test Not
Functional” (or similar title) trouble-
shooting chart.
• Count flashes to get service codes.
(Each flash lasts 1/2 second.)
Code 12 looks like:
❊
PAUSE
❊❊
FLASH (pause) FLASH FLASH
(FLASH = 1, FLASH FLASH = 2.
(Put 1 and 2 together = code 12.)
Code 23 looks like:
❊❊
PAUSE
❊❊❊
FLASH FLASH (pause)
FLASH FLASH FLASH
• All codes are 2 digits long.
• The pause between each digit is 2
seconds.
• After all codes are sent, the whole
group is sent again just one more
time (so you can double check your
code list).
• The longer pause between each
code is 4 seconds.
Example of code 12 only:
❊
PAUSE
❊❊
FLASH (pause) FLASH FLASH
(longer pause)
❊
PAUSE
❊❊
FLASH (pause) FLASH FLASH
Example of code series 12 and 42:
❊
PAUSE
❊❊
FLASH (pause) FLASH FLASH
(longer pause)
❊❊❊❊
PAUSE
❊❊
FLASH FLASH FLASH FLASH (pause)
FLASH FLASH
(longer pause)
❊
PAUSE
❊❊
FLASH (pause) FLASH FLASH
(longer pause)
❊❊❊❊
PAUSE
❊❊
FLASH FLASH FLASH FLASH (pause)
FLASH FLASH
5) Turn Ignition Key to OFF Position.
At this point you can either: