AcuRite 00282 Thermometer - Manual (Page 10)

10
Care & Maintenance
Store in a dry location at room temperature. Clean thermometer with a soft,
damp cloth. Temperature probe should be wiped clean with warm water
immediately after direct contact with foods.
DO NOT place display unit on or near hot surfaces. DO NOT heat beyond
thermometer’s temperature capacity. DO NOT use in oven. DO NOT wash in
dishwasher. DO NOT immerse in water or use caustic cleaners or abrasives.
DO NOT allow any part of the temperature probe or probe wire to come into
direct contact with flames or flare-ups. DO NOT bend or crimp the temperature
probe cord. DO NOT lift or move the thermometer by the temperature probe
wire connection.
Specifications
TEMPERATURE RANGE -40ºF to 450ºF; -40ºC to 232ºC
Probe cord heat resistant up to 700ºF (371ºC)
TIMER RANGE 9 hours, 59 minutes, 59 seconds
REMAINING COOK TIME RANGE 9 hours, 59 minutes
WIRELESS RANGE 200 ft / 60 m depending on home
construction materials
POWER Thermometer: 3 x AA alkaline batteries
Pager: 2 x AAA alkaline batteries
FCC Information
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:
1- This device may NOT cause harmful interference, and
2- This device must accept any interference received, including interference that may cause undesired operation.
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the
user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equip-
ment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, There is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment.
Such modifications could void the user authority to operate the equipment.
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation of the device.