AcuRite 00282 Thermometer - Manual (Page 9)

9
Check Probe
“CHECK PROBE” indicates a probe error and is shown with a diagnostic code:
Diagnostic
Code
Problem Solution
No
Probe cord is not connected
to the thermometer.
Verify cord connection is
secure or reconnect cord.
SC
Probe cord is not functioning
properly. Cord may have
been damaged or exposed
to extreme heat.
Check the wire and connection
for damage or excessive heat.
Replace cord.
Remote Pager
Lights Solution
Red & Green Blinking No wireless connection. See Troubleshooting tips.
Red Solid Replace the batteries.
Troubleshooting
Problem Possible Solution
Inaccurate
temperature
• Use standard alkaline batteries. Do not use
heavy duty or rechargeable batteries.
Check Probe • Review Probe Messages (above)
Display screen
not working
• Verify batteries are installed correctly. Batteries
may need to be replaced.
Pager lights are blinking
• Relocate the thermometer and pager.
The units must be within 200 ft (60 m) of each
other.
• Make sure both units are placed at least 3 feet
(.9 m) away from electronics that may interfere
with the wireless communication (such as TVs,
microwaves, computers, etc).
If your AcuRite product does not operate properly after trying
the troubleshooting steps, visit www.AcuRite.com or call
(877) 221-1252 for assistance.