ACU-RITE DRO 200M - Manual (Page 24)

DRO 200M Readout Operations
17
TOOL
DIA
. 5 0 0 ENTER
Using Tool Offsets
First enter the tool diameter.
Then select the edge you want to use for the axis you want to move.
While you are moving, the readout display will indicate if a tool is being
compensated for.
Right edge
6
X 0.000 ABS
Left edge
4
X -0.500 ABS
X -0.250 ABS
Always use
this when
drilling.
5
Center
Left
edge
Right
edge
Front
edge
Back
edge
To check your tool compensation before
you move, press
TOOL
DIA
. Press it again to
return to the position display.
If the right edge is at absolute zero-
-