Garmin GPS II Plus - Manual (Page 97)

91
Messages (cont.)
No RTCM Input—Beacon receiver is improperly connected or
baud rates do not match.
Poor GPS Coverage—The unit cannot acquire the necessary
number of satellites to compute a position. Try another loca-
tion with a clearer view of the sky.
Power Down and Re-init—The GPS II+ cannot calculate a
position due to abnormal satellite conditions. Turn the unit off,
and use other means to verify the last position shown. Try the
unit again later, possibly in a different location.
Real Time Clock Failed—The unit’s internal clock has failed.
Take your unit to an authorized GARMIN dealer for repairs.
Read Only Mem has Failed—The permanent memory has
failed and the unit is not operable. Take your unit to an autho-
rized GARMIN dealer for repairs.
Received an Invalid WPT—A waypoint was received during
upload transfer that has an invalid identifier.
Receiver has Failed—A failure in receiver hardware has been
detected. If this message persists, do not use the unit and take
it to an authorized dealer for repair.
Route is Full—You have attempted to add more than 30 way-
points to a route.
RTCM Input has Failed—DGPS data being received has been
lost. You are no longer receiving the beacon signal.
Searching the Sky—The GPS II+ is in searching the sky for
almanac data or the unit is in AutoLocate mode.
Stored Data was Lost—All waypoints, routes, time, and
almanac data have been lost due to battery failure, or the
receiver’s memory has been cleared.
Track Memory is Full—You have used all 1024 track log
points in the GPS II+. Delete unwanted track points to make
room for new entries.
Transfer has been Completed—The unit has finished
uploading or downloading information to the connected
device.
WPT Memory is Full—You have used all 500 waypoints in
the GPS II+. Delete unwanted waypoints to make room for
new entries.
Appendix D
gps ii + 8/4/98 3:29 PM Page 91