Garmin GPSMAP 196 - Manual (Page 115)

To set up Loran TD from the Main Menu:
1. Press MENU twice to show the Main Menu.
2. Use the ROCKER to highlight Setup on the vertical tab list.
Then select Location from the row of horizontal tabs.
3. Using the ROCKER, highlight the Location Format field,
and press ENTER.
Location Tab of the Setup Tab
4. Highlight Loran TD, and press ENTER.
5. Highlight the Setup button located on the right side of the
Location Format field, and press ENTER. The Loran TD
Setup window appears.
6. To change the settings of any of the five fields, highlight the
field, press ENTER, enter the setting using the ROCKER,
and press ENTER.
7. When finished, highlight the Save button, and press ENTER.
LORAN TD Setup
If the active GRI Chain, secondary stations, or offsets have been
changed since the waypoint was created, the waypoint now
references the active GRI chain and secondary stations and adjust
the TD coordinates accordingly. Remember that the GPS is not
relying on the LORAN signal for navigation and actually converts
the TD coordinate to a useful latitude and longitude coordinate
before storing the waypoint to memory or using it for navigation.
Because of this, the unit can navigate to a TD coordinate anywhere
in the world.
You must know your GRI chain number and/or secondary stations
to create a LORAN TD location. For more information read our
LORAN TD Position Format Handbook, available at the Garmin
Web site, at www.garmin.com/support/userManual.html .
GPSMAP 196 Pilot’s Guide 107
A
PPENDIX
> L
ORAN
TD S
ETUP