Garmin StreetPilot c510 - Manual (Page 31)

c510 Owner’s Manual 
a
PPendix
a
PPendix
Mounting on Your Dashboard
Use the enclosed mounting disk to
mount your unit to the dashboard and to
comply with certain state regulations.
Caution: The permanent
mounting adhesive is extremely
difficult to remove after it is installed.
1. Clean and dry the dashboard where
you are placing the disk.
2. Remove the backing from the
permanent mounting adhesive on the
bottom of the disk.
3. Place the disk on the dashboard.
4. Remove the clear plastic cover from
the top of the disk.
5. Place the suction cup mount on top
of the
disk. Flip
the lever
down
(toward
the disk)..
Resetting Your c510
If your unit locks up (freezes up), press
and hold the power button to turn off
the unit. Then turn the unit back on. If
this does not help, reset your c510.
To reset the c510:
1. Place your thumb nail in the groove
located under the Garmin logo on the
faceplate.
2. Gently pull off
the faceplate.
3. Press the
Reset button.
4. Connect the
c510 to a
power source using the power cable.
The c510 should automatically turn
back on and operate normally.
notE: If you need to reset your unit
often, update the system software.
See page 25 for information about
updating the software.
Dsk
Sucton
cup
mount
Lever
Reset button
Power button Faceplate