Garmin GPSMAP 7215 - Manual (Page 72)

66 GPSMAP ® 6000/7000 Series Owner’s Manual
Device Configuration
Configuring the Appearance of Other Vessels
Note: The Fishing chart and Mariner’s Eye 3D are available with a preprogrammed BlueChart g2 Vision
data card.
1. From the Home screen, select
Charts .
2. Select Navigation Chart , Fishing Chart , Perspective 3D , or Mariner’s eye 3D .
3. Select Menu > other Vessels > Display Setup .
4. Complete an action:
• Select Display Range to indicate the distance from your location within which AIS vessels appear.
Select a distance.
• Select MARPA > Show to show information about MARPA-tagged vessels.
• Select Details > Show to show details about other vessels.
• Select Proj. Heading to set the projected heading time for MARPA-tagged vessels. For the GPSMAP
6000 series, use the Rocker or the Numeric Keypad to enter the heading. For the GPSMAP 7000
series, use the on-screen keyboard. Select Done .
• Select trails to show the tracks of AIS vessels. Select the length of the track that appears using a trail.
Information about Your Boat
Calibrating a Water Speed Device
If you have a speed-sensing transducer, you can calibrate that speed-sensing device.
1. From the Home screen, select
Configure > My Boat > Calibrate Water Speed .
2. Follow the on-screen instructions.
Note: If the boat is not moving fast enough or the speed sensor is not registering a speed, a “Speed too
low” message appears. Select oK , and safely increase the boat speed. If the message appears again, stop
the boat, and ensure that the speed-sensor wheel is not stuck. If the wheel turns freely, check the cable
connections. If you continue to get the message, contact Garmin Product Support.
Setting the Fuel Capacity of Your Boat
1. From the Home screen, select Configure > My Boat > Fuel Capacity .
2. Enter the combined fuel capacity of all the engines on your boat:
• For the GPSMAP 6000 series, use the Rocker or the Numeric Keypad.
• For the GPSMAP 7000 series, use the on-screen keyboard.
3. Select Done .