Garmin GPS 92 - Manual (Page 78)

Messages
APPENDIX C
detected excessive drift in its internal crystal oscil-
lator which may result in longer acquisition time.
Take the unit to an authorized service center.
Poor GPS Coverage—The unit cannot acquire
the necessary number of satellites to compute a
position. Try another location with a clearer view of
the sky.
Power Down and Re-init—The unit is not able to
calculate a position due to abnormal satellite con-
ditions. Turn the unit off and verify the last posi-
tion shown by other means. Try the unit again later,
possibly in a different location.
Read Only Mem has Failed—The permanent
memory has failed and the unit is not operable.
Take the unit to an authorized service center.
Received an Invalid WPT—A waypoint was
received during upload transfer that has an invalid
identifier.
Route Waypoint Can’t be Deleted—The way-
point you are trying to delete is part of a route.
Delete the waypoint from the route before remov-
ing it from memory.
Receiver has Failed—A failure in receiver hard-
ware has been detected. If this message persists,
take the unit to an authorized dealer
Route is Full—You have attempted to add more
than 30 waypoints to a route.
Route is not Empty—You have attempted to copy
into a route already in use.
Route Waypoint was Deleted—A route way-
point entered does not exist in the database and
has been deleted from the route.
RTCM Input has Failed—DGPS data being
received has been lost. You are no longer receiving
the beacon signal.
Searching the Sky—The unit is in searching the
sky for almanac data or the unit is in AutoLocate
mode.
Start Altitude Change—The altitude change
entered on the VNAV page is about to begin.
Steep Turn Ahead—This message appears
approximately one minute prior to a turn that
requires a bank angle in excess of 25 degrees in
order to stay on course.
Stored Data was Lost—All waypoints, routes,
time and almanac data has been lost due to battery
failure or clearing the receiver’s memory.
SUA Ahead < 10 min—Your projected course
and current altitude will place you within a SUA
within 10 minutes, based on your current track
over ground.
SUA Near and Ahead—Your present position is
within 2 nm of a SUA based upon your current
course and altitude.
Timer Has Expired—The countdown timer has
expired.
Track Memory is Full—You have used all 2048
track log points in memory. Delete unwanted track
data to make room for new entries.
Transfer has been Completed—The receiver is
finished uploading or downloading information to
the connected device.
Vertical Nav Cancelled—The VNAV function has
been cancelled due to a change in the active route.
WPT Memory is Full—You have used all 500
waypoints. Delete unwanted waypoints to make
room for new entries.
72
92 manual 4/15/98 3:49 PM Page 72