Dell UPS 10000R User Manual
Page 21
Advertising
19
Installation and Startup
|
Removing the Terminal Block Cover
Terminal Block
Cover
Knock-out Hole
1
Switch off utility power at the distribution point where the UPS will be connected. Be absolutely
sure there is no power.
2
Remove the terminal block cover (two screws) and retain.
3
Remove the knock-out hole in the terminal block cover for the input conduit. The hole must
accommodate 1” or 1.5” (25.4 mm or 38.1 mm) Intermediate Metal Conduit (IMC).
Advertising