American Magnetics 4Q1010PS-430 Integrated Power Supply System - Manual (Page 179)

Rev. 5 161
Appendix
Power Supply Details
A.11 Power Supply Details
This section provides the technical details of the individual power supply
component of the AMI-supplied Model 4Q1010PS-430 Power Supply
System.
Warning
All power supply parameters, both hardware and software, have
been set by AMI, and no field adjustments or reconfiguration of the
power supply should be attempted in the field.
Service must be referred to authorized personnel. Using the power
supply in a manner not specified by AMI may impair the protection
provided by the power supply. Observe all safety precautions noted
throughout this manual.
Note
These individual power supply unit details are provided for
reference only. Some of the basic power supply parameters given in
this section will not apply as configured by the factory in the closed
loop current feedback configuration under control of the AMI Model
430 Programmer. Refer to section A.10 on page 158 and System
Specifications on page 8 for additional specifications relating to the
overall system and individual components.
An AMI Model 430 Power Supply Programmer and Kepco BOP series
power supply (also referred to in this manual as “Model 4Q1010PS”) are
configured to make up the 4Q1010PS-430 Power Supply System. The
Model 4Q1010PS is a ±10
1
volt, ±10 ampere, 4-quadrant, voltage and
current stabilized DC supply. Refer to section A.11.1 for additional
electrical characteristics.
1. Due to continuous discharge power limitations present in the BOP
series supplies, for maximum safety AMI limits both the charging and
discharging voltage to a maximum of 10 volts via the Model 430 Pro-
grammer, effectively limiting the available power to 100 watts.