Installation and setup, Direct network connection, Power adapter – AASTRA 6730i Installation Guide EN User Manual
Page 9
Installation and Setup
6
41-001277-06 Rev 00 – 07.2011
Installation and Setup
If your System Administrator has already setup your phone, please refer to the Aastra 6730i IP Phone User Guide for call
handling information or contact your System Administrator.
Direct Network Connection
The port marked with LAN is used to connect the phone to the network.
Power Adapter
Use the power adapter (provided) with your phone and plug your phone into a power source.
Note:
For power, use the 5V AC Power Adapter (limited power source (LPS) power supply, Input rated 100-240Vac. 50-60Hz,
0.3A. Output rated 5Vdc, 2A min, included only in specific Aastra ordering SKUs) to connect from the DC power port on
the phone to a power source
Ethernet
Cable
Other Network Devices
Separate
Network
Jack
Network Jack
(if Inline power provided,
do not install the power adapter)
To Network
Power
Adapter
Power Adapter
Connection