AASTRA 6737i Installation Guide EN - Manual (Page 13)

Installation and Setup
41-001371-00 Rev 01 – 07.2011
9
Connecting a Handset or Headset
Handset
Note:
1. You should connect the power supply to a surge protector or power bar. All Ethernet cables used must be mini-
mum category 5/5e straight-through cables, such as the cable provided with your phone.
2. Category 6 straight through cables are recommended for Gigabit Ethernet performance.
1. Turn the phone over and locate the handset jack marked
j.
2. Insert one end of handset cord into the jack until it clicks into place.
3. Route the handset cord through the groove as shown in the illustration below.
4. Attach the handset to the other end of the handset cord.
PoE
Power injector
(if Inline power is
not provided)
Power Outlet
To Network
Jack
To Phone
Ethernet
Cables
Network Jack
To PoE
To Handset
To Headset