AASTRA 6737i Installation Guide EN - Manual (Page 14)

Installation and Setup
10
41-001371-00 Rev 01 – 07.2011
Headset (Optional)
Desk or Wall Installation
Install on the Desk
The desk installation for the 6737i IP phone consists of two legs that attach to the back of the phone near the top cor-
ners. A total of four different viewing angles allows users to personalize their phone viewing preference.
1. Turn the phone over and locate the headset jack marked
f
.
2. Insert the headset cord into the jack until it clicks into place.
3. Route the headset cord through the groove as shown in the above illustration.
1. Attach each leg by inserting the tabs on the leg into the slots on the bottom of the phone. There are three pair of
leg slots on each corner of the phone; each leg uses two pairs (1&2, or 2&3) giving two leg positions designating
different viewing angles. Furthermore, the legs can be reversed which offer two additional viewing angles.
2. For a higher viewing angle, use the second and third slots from the top
3. For a lower viewing angle, use the first and second slots from the top.
4. Push the stand towards the phone until it snaps into place.
Three stand slot locations
for customizing the height
of the desk phone.
Total 4 Viewing Angles
20.7 deg.
Incline Angle
23.3 deg.
Incline Angle
26.6 deg.
Incline Angle
30.9 deg.
Incline Angle