AASTRA DT292 for MX-ONE User Guide EN - Manual (Page 95)

95 DT292
Installation
Charging the battery
Important!
Only use the equipment designed for the DT292 phone, see below.
* EU=European union, UK=United Kingdom, AU=Australia.
Place the cordless phone in the charger as shown in the
figure below.
The battery is being charged when the lower green LED (Light
Emitting Diode) on the charger is on (and the battery meter on the
display flashes). If the battery is completely empty it can take a few
minutes before the lower green LED on the charger is lit.
When the battery is 90% charged, the LED starts flashing (3
second intervals) and when the battery is fully charged, trickle
charging starts (LED lights up for 1 second every 30 seconds) and
the battery is ready.
Notes:
Place the DT292 in the charger and charge it for at least 4
hours before using it the first time.
Make sure the local mains voltage corresponds to the
voltage on the charger.
Do not connect the phone to the charger without a battery.
Product description Identification on product
Power adapter for DT292, EU * BMLNB 101 17/1
Power adapter for DT292, UK * BMLNB 101 17/2
Power adapter for DT292, AU * BMLNB 101 17/3
Power adapter 110V for DT292 BMLNB 101 17/6
Power Supply for Rack charger DT292 BMLNB 101 55/1