EVS XEDIO Manager Version 3.1 - January 2011 User Manual - Manual (Page 27)

Issue 3.1.C Xedio Suite Version 3.1 - User Manual – Xedio Manager
EVS Broadcast Equipment – January 2011
18
4. LinX and
Direct Access
4.1 INTRODUCTION
Xedio “Add-On” for EVS Video Server is based on LinX protocol and XT Gateway.
The LinX Application Programming Interface is an integrated API used to access
the EVS family video servers through Ethernet/IP connection.
Xedio can access EVS video server disks (e.g. XT[2], XS) and use the media
stored on EVS server thanks to XTGateway, provided that they have previously
been configured. Xedio will then be able to see, display, search and access clips
and record trains on EVS video servers. New clips could be created in CleanEdit
from EVS video servers.
Two items are available in the LinX category. They are detailed in the table below.
Item Description
EVS Video Server Defines setup parameters for an EVS video server which
will be used by CleanEdit to see, display, search and
access clips and record trains.
EVS Video Server
Group Defines the parameters of the web services used to
interact between Xedio and the EVS video servers.
All the steps below must be followed.
4.2 GENERAL CONFIGURATION
PARAMETERS
The following parameters must be defined from Softwares > Parameter Profiles >
General > General tab:
• Notification Center Address: set the IP address with port 48888.
Example: 172.22.23.9:48888
• XedioBroker Address: set the IP address with port 8762.