MSD 8110 Dist. Hold Down Clamp, Billet, Chevrolet Installation User Manual
Billet distributor hold down clamp, Pn 8110
Billet Distributor Hold Down Clamp
PN 8110
Parts Included
1 - Billet Clamp
1 - 3/8" - 16 x 1" set screw
1 - 3/8" - 16 nut
1 - 3/8" Lock Washer
1 - 3/8" Flat Washer
Note: The position of the Billet Hold Down Clamp is imperative to its operation. The end points of
the clamp must seat squarely on the intake manifold as well as the distributor collar.
INSTALLATION
1. Install the set screw into the intake manifold using a 3/16" Allen wrench.
2. Install the Billet Clamp, flat washer, lock washer and the nut on the set screw.
3. Position the clamp on the distributor
collar and tighten the nut. Figure 1
shows the correct installation of the
clamp. If the clamp is excessively
angled and the end points of the clamp
do not properly seat, the clamp will not
tighten properly.
Figure 1 Correct Billet Hold Down Installation.
M S D I G N I T I O N
• w w w . m s d i g n i t i o n . c o m • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4