MSD 8728 Soft Touch Rev Control Installation User Manual
Page 2
Advertising
2
INSTALLATION INSTRUCTIONS
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
WIRING
WARNING: High voltage is present on the coil terminals. Do Not touch the coil terminals or
tower when the engine is cranking or running.
Red
Connects to a switched 12 volt source.
Black
Connects to ground on the engine.
Green
Connects to the coil negative (-) terminal.
Trigger Pickup Wires
White
If the distributor is triggered by breaker points or an amplifier, this wire needs to be
spliced to its trigger wire.
Violet
If the distributor uses a magnetic pickup, this wire needs to be spliced into the positive
mag pickup wire.
Figure 3 Wiring to a Points/Amplifier Ignition.
Advertising