MSD 6012 GM LS2_7 Ignition Control, 06-On 58-Tooth Crank Installation - Manual (Page 3)

INSTALLATION INSTRUCTIONS 3
M S D I G N I T I O N
• W W W . M S D I G N I T I O N . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4
2-PIN CONNECTOR, ACCESSORIES
PINK Pin-B Step Retard. When 12-volts are supplied, the Step Retard is activated.
BLUE Pin-A Two-Step. When 12-volts are supplied, the RevLaunch rpm value is active.
16-PIN CONNECTOR WIRE LOCATION
GRAY Pin-A Ground
PINK Pin-B 12 Volt Supply
BROWN/WHITE Pin-C Cam Sensor Signal
RED/GREEN Pin-D Coil-2
BROWN/GREEN Pin-E Coil-4
WHITE/BLUE Pin-F Coil-6
VIOLET/BLUE Pin-G Coil-8
YELLOW Pin-H Tach
BROWN Pin-J Sensor Ground
LT. GREEN Pin-K MAP Sensor Signal
RED Pin-L Coil-7
GREEN Pin-M Coil-5
LT. BLUE Pin-N Coil-3
VIOLET Pin-P Coil-1
ORANGE/YELLOW Pin-R Crank Sensor Signal
ORANGE Pin-S 5 Volt Supply
Figure 1 Wiring the MSD 6LS-2 Controller.