MSD 8529 Oldsmobile V8 Ready to Run Distributor Installation - Manual

WARNING: Before installing the MSD Ready-to-Run Distributor, disconnect the battery cables.
When disconnecting the battery cables, always remove the Negative (-) cable first
and install it last.
Note: The terminals of this Ready-to-Run Distributor require spark plug style terminals. You may need
to change the terminals and boots of your wires. MSD offers two kits, PN 8849 or PN 8848 that are
supplied with nine boots and terminals.
TIMING FUNCTIONS
Before continuing with the installation, here are a few definitions you should be aware of:
Initial Timing: This is the base timing (also referred to as idle timing) of the engine before the centrifugal
advance begins.
Centrifugal Advance: The centrifugal (or mechanical) advance mechanism is made up of weights,
springs and an advance stop bushing. The amount of advance is controlled by the stop bushing while
the springs determine the rate of advance. If you ever wish to lock out the centrifugal advance, refer
to the centrifugal advance section.
Total Timing: This is the total of the initial timing plus the centrifugal advance added together. Example:
10° Initial + 25° centrifugal = 35° Total Timing. (When checking Total timing, disconnect and cap the
vacuum canister and plug the vacuum line.)
Vacuum Advance: The vacuum advance will advance the timing up to 10° during partial throttle
driving (with 15 lbs of vacuum). The vacuum line should be routed to a ported vacuum outlet above
the throttle plates. This line should be disconnected and plugged when setting the timing.
Note: MSD Distributors are supplied with the heavy (slow) advance springs and the 21° stop bushing
installed. This is to prevent detonation in certain applications. Review the information on pages
2-4 to determine the best advance curve for your application.
MSD Pro-Billet Ready-to-Run Distributors
Pontiac, PN 8528
Oldsmobile, PN 8529
Parts Included:
1 - Pro-Billet Distributor
1 - Rotor, PN 8467
1 - Distributor Cap, PN 8433
1 - Wire Retainer
2 - 1.5" Self Tapping Screws
2 - 10-32 x 3/4" Socket Head Screws
M S D I G N I T I O N
• W W W . M S D I G N I T I O N . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4
Important: Read these instructions before attempting the installation.
ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered
in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdignition.com/registration.
1 - Advance Kit
1 - 3-Pin Harness
1 - Gasket
1 - Tube of Gear Lubricant
1 - Vacuum Lockout
1 - Gray Tach Jumper