MSD 8205 Blaster 2 Coil, Ford High-Performance Installation - Manual

Parts Included:
1 - Blaster 2F Coil, PN 8205
Note: The Blaster 2F Coil is designed as a replacement for coils with a "horse shoe" connector. When
installing to a factory Ford ignition system, a 0.8 ohm ballast resistor or resistor wiring MUST
be installed. MSD offers this Ballast Resistor as PN 8214.
WARNING: Failure to use a ballast resistor with the factory Ford ignition system could result in
personal injury or component failure.
The Blaster Coil is designed to mount in most factory canister coil mounts. MSD also offers a Coil
Bracket, PN 8213. It is recommended to mount the coil in an upright position.
WARNING: During installation, disconnect the battery cables. When disconnecting the battery,
always remove the Negative (-) cable first and install it last.
WIRING TO AN MSD 6 OR 7 SERIES IGNITION
The MSD 6 is a Capacitive Discharge Ignition. It receives 12 volts directly from the battery and is
responsible for delivering the positive voltage to the coil. Therefore, a 12 volt source wire is not required
at the coil. When the installation with an MSD Ignition is complete, there will only be two wires making
direct contact to the coil terminals: The Orange Wire from the MSD connects to the coil positive (+)
terminal. The small Black wire from the MSD connects to the coil negative (-) terminal (Figure 1).
Figure 1 Wiring to an MSD 6 or 7 Series Ignition Control.
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered
in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.
MSD Blaster 2F Coil
PN 8205