MSD 8655 Universal Crank Trigger Kit Installation - Manual (Page 3)

INSTALLATION INSTRUCTIONS 3
AUTOTRONIC CONTROLS CORPORATION • 1490 HENRY BRENNAN DR., EL PASO, TEXAS 79936 • (915) 857-5200 • FAX (915) 857-3344
Figure 4 Centering the Pickup Mounting Hole.
PICKUP HOLE
To machine the Pickup Holder, the bracket and trigger wheel must be installed. This is necessary
to center the Non-Magnetic Pickup to the trigger wheel (Figure 4).
1. Bolt the Pickup Holder to the bracket.
2. Locate the center of the trigger wheel and mark this location on the Pickup Holder.
3. Use an 11/16” drill bit, and tap the hole to ¾-16 threads.
4. Install the pickup and lock nut. Set the air-gap to .050”-.080” (Figure 5).
Figure 5 Setting the Pickup Air-Gap.