MSD 8261 HVC-2 Coil, 7 Series Ignitions Installation - Manual

M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
WARNING: Disconnect the battery during installation. When disconnecting the battery, always
remove the negative cable first and install it last.
MSD HVC-2 Coil
PN 8261
The HVC-2 Coil is designed to be used with an MSD 7, 8 or 10 Series Ignition Control only.
It is recommended to use 14-Gauge wiring for the primary coil wiring.
INSTALLATION
1. The Coil can be mounted in any position, but should be away from direct heat sources.
Use the Coil as a template and mark the location of the mounting holes. Use an 3/16” bit
to drill the holes.
2. Install the supplied vibration mounts to the coil and install the coil.
3. The MSD Orange wire connects to coil positive (+). Black connects to coil negative (-).
Note: It is recommended to use 14-Gauge wiring for the primary coil wiring.
4. Connect the coil secondary wire to the coil and distributor cap.
Parts Included
1 - HVC-2 Coil
4 - Vibration Mounts and Hardware
2 - Brass Lock Washers
2 - Ring Lug Terminals
2 - Brass Screws
WARNING: Very high voltages are present at the coil when the engine is running. Never connect
any test equipment or touch the coil while the engine is cranking or running.
ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered
in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.