MSD 82933 Modified Distributor Cap and Rotor for Acura Integra GSR 94-01 Installation - Manual (Page 2)

2 INSTALLATION INSTRUCTIONS
M S D I G N I T I O N
• W W W . M S D I G N I T I O N . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • FA X ( 9 1 5 ) 8 5 7 - 3 3 4 4
ASSEMBLING THE COIL WIRE
Once the cap is installed and the coil is wired, you will need to
assemble a coil wire. You will need a razor blade and a 4-inch vice.
The Mini-Stripper-Crimper is an all in one spark plug wire stripper
and crimp tool. It will work with both MSD 8.5mm Super Conductor
and 8mm Heli-Core wires to produce a strong, professional crimp.
TERMINALS
MSD offers several different terminals with our Universal wire sets.
There are two terminal styles used, either a standard style or the
Dual Crimp Terminal (Figure 5). The standard design requires
stripping more of the wire sleeve because the conductor will be
bent under the terminal. The Dual Crimp has specific crimp tabs
for the conductor which require needle nose pliers.
Figure 5 Identifying the Different
Style Terminals.
Figure 3 Wiring an MSD SCI Ignition with a Blaster SS Coil.
5. Replace the rotor. Depending on the application, the dust cover may need to be removed or the
engine may need to be rotated to access the rotor retaining screw (figure 4). Install the cap and
wires.
ROTOR RETAINING SCREW
Figure 4 Replacing the Rotor.
REMOVE DUST COVER