MSD 8650 Pontiac V8 Crank Trigger Kit Installation User Manual

Page 2

Advertising
background image

FRM16022

Created 01/95

Printed In U.S.A.

Figure 2 Pickup Centered on the Trigger Wheel.

INSTALLING THE
TRIGGER WHEEL

1. Position the No. 1 cylinder
under compression at the desired
total timing. Install the trigger
wheel centering ring onto the
harmonic balancer of the engine.

2. Position the trigger wheel onto
the harmonic balancer and
centering ring so one of the four
magnets lines up with the center
of the non-magnetic pickup. Make
sure the wheel is mounted so it
rotates in the direction of the arrow
on the wheel. If necessary, slide
the pickup in its mount until it
properly lines up with the trigger
wheel magnet.

3. Check and make sure the wheel is positioned correctly with the pickup and
torque the trigger wheel bolts to 25 - 30 lb-ft.

4. The pickup should be centered to the edge of the crank trigger wheel (Figure 2).
If not, it may be necessary to add or delete shims to the pickup bracket to achieve
the proper position.

Limited Warranty

A

utotronic Controls Corporation warrants MSD Ignition products to be free from defects in material

and workmanship under normal use and if properly installed for a period of one year from date of
purchase. If found to be defective as mentioned above, it will be replaced or repaired if returned prepaid
along with proof of date of purchase. This shall constitute the sole remedy of the purchaser and the sole
liability of Autotronic Controls Corporation. To the extent permitted by law, the foregoing is exclusive
and in lieu of all other warranties or representations whether expressed or implied, including any implied
warranty of merchantability or fitness. In no event shall Autotronic Controls Corporation be liable for
special or consequential damages.

Service

In case of malfunction, this MSD component will be repaired free of charge according to the terms

of the warranty. When returning MSD components for service, Proof of Purchase must be supplied for
warranty verification. After the warranty period has expired, repair service is charged based on a minimum
and maximum charge.

Send the unit prepaid with proof of purchase to the attention of: Customer Service Department,

Autotronic Controls Corporation, 1490 Henry Brennan Drive, El Paso, Texas 79936.

When returning the unit for repair, leave all wires at the length in which you have them installed.

Cutting wires close to the unit will void your warranty. Be sure to include a detailed account of any
problems experienced, and what components and accessories are installed on the vehicle.

The repaired unit will be returned as soon as possible after receipt, COD for any charges. For more

information, call the MSD Customer Service Line (915) 855-7123. MSD technicians are available from
8:00 a.m. to 5:00 p.m. Monday - Friday (mountain time).

Advertising