MSD 8217 Hold-Down, Coil Wire Installation - Manual

WARNING: High voltage may be present on the coil terminals.
Do not touch the coil terminals while the engine is
cranking or running!
Parts Supplied
1 – Coil Wire Retainer
1 – Wire Tie
1 – Spacer
Coil Wire Retainer
PN 8217
The Coil Wire Retainer is designed to work with MSD Blaster Coils
that have a canister style housing and other canister type coils.
Coils with a short coil tower will require the use of the supplied
spacer ring. Slide the spacer ring up from the bottom of the coil to
the upper lip, then clamp the coil retainer over the coil. Coils with
tall towers do not require the use of the coil spacer ring.
After clamping the retainer over the coil and coil wire, use the
supplied wire tie to secure it in place.
Figure 1
Spacer if
Required
Limited Warranty
M
SD warrants this product to be free from defects in material and workmanship under its intended normal use*,
when properly installed and purchased from an authorized MSD dealer, for a period of one year from the date of
the original purchase. This warranty is void for any products purchased through auction websites. If found to be
defective as mentioned above, it will be repaired or replaced at the option of MSD. Any item that is covered under
this warranty will be returned free of charge using Ground shipping methods.
This shall constitute the sole remedy of the purchaser and the sole liability of MSD. To the extent permitted by
law, the foregoing is exclusive and in lieu of all other warranties or representation whether expressed or implied,
including any implied warranty of merchantability or fitness. In no event shall MSD or its suppliers be liable for special
or consequential damages.
*Intended normal use means that this item is being used as was originally intended and for the original application
as sold by MSD. Any modifications to this item or if it is used on an application other than what MSD markets the
product, the warranty will be void. It is the sole responsibility of the customer to determine that this item will work for
the application they are intending. MSD will accept no liability for custom applications.
Service
In case of malfunction, this MSD component will be repaired free of charge according to the terms of the warranty. When
returning MSD components for warranty service, Proof of Purchase must be supplied for verification. After the warranty period
has expired, repair service is based on a minimum and maximum fee.
All returns must have a Return Material Authorization (RMA) number issued to them
before being returned. To obtain an RMA number please contact MSD Customer Service at 1 (888) MSD-7859 or
visit our website at www.msdperformance.com/rma to automatically obtain a number and shipping information.
When returning the unit for repair, leave all wires at the length in which you have them installed. Be sure to include a detailed
account of any problems experienced, and what components and accessories are installed on the vehicle. The repaired unit will
be returned as soon as possible using Ground shipping methods (ground shipping is covered by warranty). For more information,
call MSD at (915) 855-7123. MSD technicians are available from 7:00 a.m. to 5:00 p.m. Monday - Friday (mountain time).
M S D • W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
© 2012 Autotronic Controls Corporation
FRM28740 Revised 01/12 Printed in U.S.A.