MSD 8210 Automatic Coil Selector Installation - Manual

Automatic Coil Selector
PN 8210
IMPORTANT: Read instructions before attempting the installation.
WARNING: High voltage is present at the Coil Selector when the engine is running. Do not touch!
The Automatic Coil Selector will switch the high voltage output from one coil to the other on redundant
ignition systems. It can be used with MSD 6 Series Ignition Controls, GM Ignition (PN 10037378), Ford
Ignition (PN M-12199-B351) and Mopar Performance Ignition (PN P4876730 and P4876728).
Note: MSD 7 Series Ignitions cannot be used with the Automatic Coil Selector.
The Coil Selector can be mounted in the engine
compartment. Make sure the secondary coil wires
reach the towers. Position the Coil Selector on a flat
surface and mark the mounting hole locations. Re-
move the unit, drill the mounting holes using a 1/8”
bit and secure the Selector.
ACCESSORIES FOR DUAL IGNITION SYSTEMS
• 90° Spark Plug Wire Boots and Terminals – Kit of nine,
PN 8850. Kit of two, PN 3311
• Blaster Coil Socket Boot and Terminal, PN 3331
• Single Pole, Double Throw Switch, PN 8807
• Tach Signal Splitter, PN 8911
Figure 1 Mounting the Coil Selector.
Parts Included In This Kit:
1 - Coil Selector
2 - Mounting Screws
M S D
• W W W . M S D P E R F O R M A N C E . C O M • ( 9 1 5 ) 8 5 7 - 5 2 0 0 • F A X ( 9 1 5 ) 8 5 7 - 3 3 4 4
ONLINE PRODUCT REGISTRATION: Register your MSD product online and you’ll be entered
in our monthly 8.5mm Super Conductor Spark Plug Wire give-away! Registering your product
will help if there is ever a warranty issue with your product and helps the MSD R&D team create
new products that you ask for! Go to www.msdperformance.com/registration.