Getting started, Connect power, Prepare the remote control – Naxa NGT-20 User Manual
Page 9: Find the correct input on your tv, Use the setup menu

Getting Started
Caution
Always follow the instructions in this chapter in sequence.
Prepare the remote control
Caution
Due to a risk of explosion! Keep batteries away from heat,
1.
Open the battery compartment.
2.
Insert 2xAAA batteries with correct polarity (+/-) as indi-
cated.
3.
Close the battery compartment cover.
Note
If you are not going to use the remote control for a long
time, remove the batteries.
Do not mix old and new batteries.
Do not mix alkaline, standard (carbon-zinc), or
rechargeable (ni-cad, ni-mh, etc) batteries.
Batteries contain chemical substances, so they
should be disposed of properly.
Find the correct input on your TV
1.
Press
to turn on this product.
2.
Turn on the TV and switch to the correct video input (refer
to the TV user manual on how to select the proper input).
Use the SETUP menu
7
Note
The type plate is located on the back of the product.
Caution
AC power cord, ensure you have
completed all other connections.
Connect power
Connect the AC power cable to a suitable wall socket.
This product is ready to be set up for use.
Risk of product damage! Ensure that the power supply
voltage corresponds to the voltage printed on the back of the
unit.
When first time power up, You’ll see Welcome Page.
It will help you to config your device.
Select Language
Adjust the position of the screen
Select network and setup
Setup the time