Ohaus GT4100DG Electronic Balances - Manual (Page 37)

37
Initialize Initialize Initialize Initialize Initialize
1. Access the submenu under the Print Options submenu.
2. If Interval was selected in the Auto Print submenu, is displayed,
and you may continue with step 3. If interval was not selected,
is displayed. Proceed to step 7.
3. to enter time interval for automatic data output when
is displayed. The current interval from to
(in seconds) is displayed.
4. to increase or to decrease the interval number.
5 .
6. to enter a range of non printing values, is dis-
played.
7 , the current value for the low end of the range is displayed with
the first digit flashing .
8. To change the number, start with
the first digit (flashing).
to change the
value to any number from -9 to +9.
A minus sign will light to indicate a
negative value.
9. When the desired value is
displayed, to accept it and
the next digit will begin flashing.
10.Set all digits in the same manner. If an error is made, to backup to
the desired digit and change it.
To exclude data To exclude data To exclude data To exclude data To exclude data
WITHIN SELECTED RANGE:
WITHIN SELECTED RANGE: WITHIN SELECTED RANGE: WITHIN SELECTED RANGE: WITHIN SELECTED RANGE:
SET non-PL < non-PH
Example:non-PL=7g, non-PH=11g
Values <7 OR OR OR OR OR >11 will be output.
To exclude data To exclude data To exclude data To exclude data To exclude data
OUTSIDE SELECTED RANGE:
OUTSIDE SELECTED RANGE: OUTSIDE SELECTED RANGE: OUTSIDE SELECTED RANGE: OUTSIDE SELECTED RANGE:
Set non-PL > non-PH
Example:non-PL=11g, non-PH=7g
Values >7 AND AND AND AND AND <11 will be output.