Ohaus GT4100DG Electronic Balances - Manual (Page 40)

40
List List List List List
This submenu can be used to output a listing of current menu settings via the RS232
interface. When selected, all menu settings for the Print menu will be output either to
an external printer or computer. To use this feature, your balance must be connected
to a computer or printer.
1. Access the submenu under the Print submenu.
2. to obtain a listing of current settings, when is dis-
played. The display indicates a series of dots traveling right to left when the
balance is sending information .
MENU LOCK-OUT PROTECTION MENU LOCK-OUT PROTECTION MENU LOCK-OUT PROTECTION MENU LOCK-OUT PROTECTION MENU LOCK-OUT PROTECTION
Access to the Calibration Calibration Calibration Calibration Calibration , User User User User User , Setup Setup Setup Setup Setup and Print Print Print Print Print menus, can be disabled using the
Lockswitch located on the PC board inside the balance. The Lockswitch locks out
menus selected in the Lockswitch menu. The default setting for the Lockswitch is
OFF.
1. Turn the display off and unplug the power cord.
WARNING
• To avoid shock hazards, always be
certain that the power cord is discon-
nected BEFORE removing the balance
cover.
• Even though the balance may have
been switched OFF, high voltage is
present inside the balance as long as
the power cord is connected.
• A power cord has been furnished with
the balance. DO NOT use any other
type of power cord other than the one
furnished.
DO NOT create a safety hazard by
defeating the grounding feature.
LOCKSWITCH
LOCATED INSIDE OF
BALANCE
2. Remove the platform and platform support.
3. Remove the two (2) cover screws and tilt the cover towards the right side of the
balance.
4. The menu Lockswitch is located on the front of the PC board. The OFF position
is to the left facing the front of the balance.
5. Select the desired position on the Lockswitch and reassemble the balance.