QNAP Security VioStor NVR (Version: 4.1.1) - Manual (Page 139)

139
6.3 Network Settings
Configure the WAN and LAN settings, DDNS service, file service, host access control,
protocol management and view the network settings in this section.
6.3.1 TCP/IP Configuration
If the NVR supports a single LAN port, select one of the following options to configure the
TCP/IP settings of the NVR.
 Obtain IP address settings automatically via DHCP
Select this option to allow the NVR to acquire an IP address on the local network
automatically if a DHCP server is available.
 Use static IP address
To assign a fixed IP to the NVR, enter the IP address, the subnet mask, and the default
gateway.
Primary DNS Server: Enter the IP address of the primary DNS server that provides the DNS
service for the NVR on the external network.
Secondary DNS Server: Enter the IP address of the secondary DNS server that provides the
DNS service for the NVR on the external network.
Note: The Jumbo Frame setting is valid in Gigabit network environment only. All the
network appliances connected must enable Jumbo Frame and use the same MTU value.