TROY Group MICR_IRD 9000 1UP MICR Printing Solutions User’s Guide - Manual (Page 98)

Section 5 Using the TROY Port Monitor
MICR Solutions User’s Guide -- Document #50-70341-001 Rev. F
5-9
Security Tab
(cont.) HP Job Password – (used only for legacy MICR
printers) enter the job password (0-65535) that
matches the job password (PJL command) set in
the MICR Secure EX printer.
Alternate Escape Sequence – (used only for
legacy MICR printer compatibility) enter the
alternate ASCII character number (0 to 255) to
replace the ASCII character 27 (escape character)
in the PCL 5 data stream sent to the printer. Press
the Alt key, and enter the ASCII character number.
Default Paper Tray Mapping – check this box to
select check paper from the default (standard
Hewlett-Packard) paper tray mapping for your
TROY MICR printer. Use this feature only if the
administrator has set up secure paper tray mapping
for the selected TROY MICR printer.
Enable MICR Mode – check this box to enable
MICR mode when printing MICR documents.
TROYmark ™ (Secure EX printers only) – select
Disable for no background image on the check or
select either Light, Medium or Dark to use a pre-
defined density level for the TROYmark
™
background image, or select Custom to use a
custom density level for the TROYmark
™
background image that best suits the design of
your check.
Inclusion and Exclusion Regions (Secure EX printers only) – enter the appropriate “X” (horizontal) and “Y”
(vertical) offset numerical values to define the top-left starting point of the inclusion region and the exclusion
region(s), and then enter the width and height numerical values to define the bottom-right ending point of the
inclusion and the exclusion region(s) for placement of the TROYmark
™
background image and exclusion areas.
Click on Test to print a sample page to verify the inclusion/exclusion region placement on the check. Make
adjustments to the numerical values as needed. Each increment in the numeric value equals 1/600th of an inch.