TROY Group MICR_IRD 9000 1UP MICR Printing Solutions User’s Guide - Manual (Page 57)

Section 4 Using the TROY Printer Utility
MICR Solutions User’s Guide -- Document #50-70341-001 Rev. F
4-10
Selecting Security
Options TROY MICR printing solutions allow convenient enabling or disabling of the built-in security options to suit
your MICR printing needs. After entering the current administrator’s (ADMIN) password in the TROY Printer
Utility Main Window, the security options specific to your TROY MICR printing solution can be individually
enabled or disabled (refer to the table below for a summary of these features).
In addition, you can also choose an alternate ASCII escape character and enter a decryption password (Secure EX
series printers only) using the Security Options screen. Do NOT use the alternate escape character unless
instructed by your system programmer or TROY Technical Support. The following table summarizes these
configurable security options:
OPTION FUNCTIONALITY
Printer Type E NABLED - allows access to MICR fonts and secure printer resources, disables jam recovery, sets print density.
D ISABLED - blocks access to MICR fonts and secure printer resources, enables jam recovery, prints PCL, etc.
Tray Mapping E NABLED - uses the tray mapping assignment set in the TROY Printer Utility.
D ISABLED - uses the printer’s factory default tray map settings.
Alt. Escape
Character ASCII N UMBER S ELECTED – uses the selected alternate ASCII character as a substitute for the ASCII escape
character (ASCII 27).
N O C HANGE - uses the standard ASCII escape character (ASCII 27) required in all PCL commands sent to the
printer.
Decryption Mode ) J OB - BY -J OB – (default) prints all encrypted and non-encrypted jobs. The decryption feature will be invoked as
needed on a job-by-job basis when an encrypted print job is detected.
A LWAYS – all PCL 5 jobs must be encrypted. Non-encrypted PCL 5 jobs will be purged.
Language
Supported A LL – (default) printer accepts all types of print jobs (PCL, PostScript, etc.).
PCL 5 – printer accepts PCL 5 print jobs only. All non-PCL 5 print jobs will be ignored.
Printer Lock PIN ) ) Enable – Enter a PIN (Personal Identification Number) between 1 – 9999 to restrict all print jobs from printing
until the user enters a valid PIN at the printer control panel.
Disable – Enter a zero in the PIN field, and then click on Update Printer to save the changes.
MICR Lock PIN ) ) Enable – Enter a PIN (Personal Identification Number) between 1 – 9999 to restrict MICR jobs from printing
until the user enters a valid PIN at the printer control panel.
Disable – Enter a zero in the PIN field, and then click on Update Printer to save the changes.
Decryption
Password ) To support encryption, a decryption password must be entered that matches the encryption password. If
decryption is not going to be used, leave the decryption password field blank.
) Secure EX Printers Only ) ) 9000 Secure EX Printers Only