Velleman VM118 User Manual
Page 10
10
All repairs should be executed by qualified technicians.
Avoid the installation of the module in locations with standing or running water or excessive humidity. Indoor use only !
SAFETY INSTRUCTIONS
Handle the module gently and carefully. Dropping it can damage the circuit board.
Never exceed the protection limit values indicated in the specifications.
As safety requirement vary, please check with your local authorities.
Facilitate the operation of the device by familiarising yourself with its adjustments and indications.
Velleman modules are not suitable for use or as part of life support systems, or systems that might create hazardous situations of kind.
WARNINGS
Repair under warranty is only possible with date and proof of purchase.
Safety & warning instructions
HINT: Return to default card address 1
If an unknown card is used, or the transmitter is not longer at the same address as the card, it is possible to force the card to
address 1.
>> > First make sure the card is powered see page 5 !
How to force to address “1”:
Hold ‘shift’
until the LED lights to enter the ‘set-up’-mode.
Press ‘4’
to force the current address to 1, LED LD8 on the card must light.
Next, press ‘shift’
several times until the LED turns off to leave setup mode.