Velleman VM151 - Manual (Page 6)

6
Use
Effect # Effect description Adjustable speed
1 Static green
2 Static blue
3 Static yellow
4 Static cyan
5 Static magenta
6 Static white
7 Hard transition red-green-blue-yellow-cyan-magenta
8 Fade red green blue red
9 Running light red green blue
10 Flame effect (3 independent flames)
11 Hard transition between all 40 colours stored in mem. 1..5
12 Fade between 8 colours stored in memory 1
13 Fade between 8 colours stored in memory 2
14 Fade between 8 colours stored in memory 3
15 Fade between 8 colours stored in memory 4
16 Fade between 8 colours stored in memory 5
17 Random colour fade
0 Static red
1) Using the RGB controller with the supplied RF remote control:
Left button:
Change effect (push until effect changes. Leds blank between each effect) Right button: effect speed change
Press and hold button until leds blank. Each press reduces
speed. 8 speed settings are available.
When minimum speed is reached, the unit will jump to max.
speed at the next press
To turn off:
Press and hold both buttons until display blanks. (A brief flash
will confirm the action)
(Current effect and current speed will be stored in memory.
At next power-up, unit will resume)
To turn back on:
Press and hold any key until outputs are turned on again.
To make the unit respond to a transmitter:
Same procedure as turn-off. New transmitter will be stored in
memory.
Unit will no longer respond to previous transmitter.
To make the unit respond to more than one transmitter:
Reset all transmitters to default code.
Make unit respond to this transmitter. All other transmitters that
are set to default code will be able to control the unit.
USE
HVM151G'1_rev2.pub
page 6
Composite
Wednesday, April 15, 2009 11:08