Installation guide – Veris Industries AE011 Install User Manual
Page 4
Z206026-0A
PAGE 4
©2011 Veris Industries USA 800.354.8556 or +1.503.598.4564 / [email protected]
05113
Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.
TM
AE010/AE011
INSTALLATION GUIDE
6. Installing the AE011 locking mechanism (optional)
Use a 6 mm (15/64”) drill bit to drill out the hole for the lock.
Note: To protect the box against damage from the drill, remove the cover by
unscrewing the retention screws.
Insert the locking mechanism into the hole from the inside of the shield.
Insert locking
mechanism upward
into hole.
Insert pin through shield
and through locking
mechanism to secure in
hole.
7. Final Assembly
To close the clear shield, squeeze both green buttons while pushing the shield into
place on the cover. Use the key to secure the lock (if the AE011 lock is installed).
The AE010 is now fully assembled.