VTech VM321-2 Manual - Manual (Page 10)

4
Getting started
Baby unit installation options
The baby unit is ready for tabletop use. Use the provided wall mount if you
want to mount it on a wall. Make sure to test the reception and the baby unit
position before completing the wall mounting installation (see Test your video
and audio monitor before use on page 20).
Tabletop to wall mount installation
Option 1: Use this method to fix the wall mount securely on the wall.
Place the wall mount on a wall and then use a pencil to mark the top two
holes as shown. Then remove the wall mount and drill two holes in the
wall (7/32” drill bit). Check for reception strength and camera angle before
drilling the holes.
If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert the wall
anchors into the holes and tap gently on the ends with a hammer until the
wall anchors are flush with the wall.
1.
2.