VTech VM321-2 Manual - Manual (Page 13)

7
Getting started
Option 2: Use this method so that you can relocate the baby unit with the wall
mount easily.
Place the wall mount on a wall and then use a pencil to mark the top and
the bottom holes as shown. Then remove the wall mount and drill two
holes in the wall (7/32” drill bit). Check for reception strength and camera
angle before drilling the holes.
If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud, insert the wall
anchors into the holes and tap gently on the ends with a hammer until the
wall anchors are flush with the wall.
1.
2.
Baby unit installation options (continued)