VTech VM321-2 Manual - Manual (Page 43)

37
Appendix
Troubleshooting (continued)
Common cure for electronic equipment.
If the video and audio monitor is not responding normally, try the following (in the
order listed):
1. Disconnect the power to the baby units and the parent unit.
2. Remove the batteries in the baby units and the parent unit. Then install the
batteries again.
3. Wait a few minutes before connecting power back to the baby units and the
parent unit.
4. Turn on the baby units and the parent unit.
5. Wait for the parent unit to synchronize with the baby units. Allow up to one minute for
this to take place.
•