Vutec LECTRIC I RF - Installation Instructions - Manual (Page 2)

Back-off the locking screw for each mounting bracket so that it is even with the inside face of the bracket.
Slightly tip the screen housing and fit it into the mounting brackets. If this is a ceiling installation, move the screen
housing toward the rear immediately after the insertion so the screen is completely hooked to the brackets
(see Figure 2).
Carefully move the screen housing side to side for final location as desired.
Tighten the locking screw of each bracket to lock the screen in place.
THIS SCREEN EQUIPPED WITH A BUILT-IN RF MOTOR. SIMPLY PLUG THE POWER CORD TO 120VAC
OUTLET FOR OPERATIONS.
ELECTRICAL
220VAC RF motor does not have a plug for the power cable; add an appropriate plug of the region for used.
Note for 220VAC RF motor:
Connect the wires as follow: Green/Yellow to Ground, Blue to Neutral, and Brown to AC Line.
Press the Arrow Down button on the transmitter to send the screen down to show position.
OPERATIONS
Press the Arrow Up button on the transmitter to send the screen to the upper limit.
Press the middle button to stop the screen travel.
CHANGING THE SCREEN UPPER & LOWER LIMITS
Send the screen down in normal mode by momentary pressing the Arrow Down button.
Changing the lower limit
The screen will come to the lower limit and stop.
Press and hold both the Up and Down Arrow buttons until the screen jog up and down in respond. Release the
buttons.
Change the lower limit by momentary pressing the Up or Down button.
Press the Stop button until the screen jog up and down in respond to registering the new lower limit. Normal
operation has been resumed after this step.
Send the screen up in normal mode by momentary pressing the Arrow Up button.
Changing the upper limit
The screen will come to the upper limit and stop.
Press and hold both the Up and Down Arrow buttons until the screen jog down and up in respond. Release the
buttons.
Change the upper limit by momentary pressing the Up or Down button.
Press the Stop button until the screen jog down and up in respond to registering the new upper limit. Normal
operation has been resumed after this step.
1 RF TRANSMITTER KIT
ACCESSORIES INCLUDED
3 MOUNTING BRACKETS WITH SCREWS