Vutec ARTSCREEN Surface Clip Instructions - Manual (Page 2)

Electrical Connections
The Art Screen comes with IR remote control for
operations. It is ready for use; no wiring connections are
required.
Place the IR sensor so that it can be seen by the
transmitter.
Plug the power cord to a 120VAC outlet.
The IR remote control has manual inputs for Home
Automation systems, i.e. AMX, Crestron, etc. See IR
remote control manual (included) for detail information.
The spring-loaded catch (Figure 3b) with SPDT switch
may be used for security purpose; its contacts may be
connected to an audible alarm system or monitoring
system. The breach of security will be activated when
the wood frame is removed.
The states of the contacts are shown when the Keeper is
not engaged with the Catch.
Contact Rating: 6Amp, 250VAC or 3Amp, 30VDC.
Open and Close Limits Setting
The Open limit switch has been properly set for correct stop position. It
should not be adjusted unless a change in the motor or the motor had been
removed for service.
Note each full turn of the limit switch (360 degrees) causes the screen to
travel approximately 1/2 inch.
1. To lower the closed limit of the Art Screen. Send the Art Screen
down to it closed position. Turn the Close limit socket
counter-clockwise (Figure 5); the Art Screen will advance downward
as each full turn is made. Stop at the desired position.
2. To raise the closed limit of the Art Screen. Send the Art
Screen down to it closed position. Determine the number
of turns to stop the screen above the desired close limit.
Turn the Close limit socket clockwise to raise the limit.
The motor will not move for this direction.
Figure 3b
Spring-loaded catch with SPDT switch
Figure 4
Side View
Figure 3a
Art Screen Frame