Vutec LECTRIC I - Installation Instructions - Manual (Page 2)

2
LectricI&III-Rev F 03/21/2011
LECTRIC I & III
WALL OR UNDER CEILING MOUNT
GENERAL
The LECTRIC I or III screen may be mounted to the wall or ceiling as shown in Figures 1 and 2. Lectric I and
Lectric III meet requirement for fire-resistant and low smoke-producing characteristics
. The screen comes with three
mounting brackets and screws as shown in Figures 3 and 4. Where possible, the mounting brackets should be installed
to rigid structural members. If this is not possible, suitable wall anchors or other mounting methods must be
considered.
Unless otherwise specified, the motor locates on the left end of the housing. The screen fabric rolls down from the
backside of the roller.
A basic Toggle switch is supplied with the screen. Decorator wall switch or other controls are optional.
Figure 1 Figure 2
Wall Mounted Ceiling Mounted
Figure 3 Figure 4
Wall Mounted Ceiling Mounted