Vutec PORTA-FOLD TRUSS - Installation Instructions - Manual (Page 2)

VUTEC CORPORATION
www.vutec.com
TEL: (954)-545-9000
FAX: (954)-545-9011
E-MAIL: [email protected]
Truss Trim Kit (Clip)
INSTALLATION INSTRUCTIONS
Assembly
1. Assemble screen frame and legs (see instructions on reverse side). Figure a
2. Attach truss legs to the frame at the color markings for
the skirt to hang a full 48”. (Note: The frame may be set
at various heights in 6” increments above or below the
color match marks.)
3. Attach the valance bar brackets to the back of the top of
the truss frame with crank bolts, matching the color
coding on the valance bracket and the frame. Attach the
valance bar to the front of the valance brackets (fig a).
4. Attach the two leg drape brackets to the sides of the
truss frame with crank bolts (fig a). Industry compatible
Porta Fold uses locking hooks to attach the valance bar
and leg drape brackets to the side of the frame.
5. Snap the screen surface onto the frame. (Follow the
directions on surface instruction sheet. Do not unfold
cold surface as it can be damaged.) Snap the leg drapes to the leg drape brackets. Snap the valance to the valance bar (fig b).
6. With one person on each side supporting the screen and trim assembly, raise the unit to a vertical position and
attach the truss feet to the bottom of the truss legs. Large screens may require additional support in the center.
7. Snap skirt to front of screen surface (fig b)
Figure b In general, reverse the above order.
Disassembly
1. Unsnap skirt from screen surface.
2. Place surface ground cloth on floor and supporting
the sides of the unit, lower to the ground.
3. Remove valance and leg drapes.
4. Remove screen surface.
5. Remove leg brackets first, then valance bar and
valance brackets.
6. Fold brackets, valance bar and drapery
and store in trim kit case.
7. Follow instructions on reverse side to disassemble
screen frame and legs
.