VEGA SOLITRAC 31 4 … 20 mA_HART - four-wire With SIL qualification - Manual (Page 19)

19
5 Connecting to power supply
SOLITRAC 31 • 4 … 20 mA/HART - four-wire
43387-EN-131119
Information:
The terminal blocks are pluggable and can be detached from the
electronics. For this purpose loosen the two lateral locking levers of
the terminal block with a small screwdriver. When loosening the lock-
ing, the terminal block is automatically squeezed out. It must snap in
place when re-inserted.
5.2 Connection - Level measurement
Non-Ex instruments and instruments with non-intrinsically safe
current output
1 1
24
/L
/N
PE
56
91
01
1
22
11 12
21
22
19
20
18
17
14
13
16
15
12
2
3
1
4
6
5
Fig. 7: Electronics and connection compartment with non-Ex instruments and
instruments with non-intrinsically safe current output
1 Voltage supply
2 Relay output
3 Signal output 4 … 20 mA/HART active
4 Signal output 4 … 20 mA/HART passive
5 Interface for sensor-sensor communication (MGC)
6 Setting the bus address for sensor-sensor communication (MGC) 1)
5 6 7 8
2
1
Fig. 8: Adjustment and connection compartment with non-Ex instruments and
instruments with non-intrinsically safe current output
1 Terminals for the external display and adjustment unit
2 Contact pins for the display and adjustment module or interface adapter
Electronics and con-
nection compartment
- Non-Ex instruments and
instruments with non-
intrinsically safe current
output
Adjustment and con-
nection compartment
- Non-Ex instruments and
instruments with non-
intrinsically safe current
output
1) MGC = Multi Gauge Communication