Cortech CREASEMASTER PLATINUM CREASING SYSTEM - Manual (Page 8)

3.0 Getting Ready
3.1 Paper Gate Adjustments
• With light to medium stock, the feed finger should be not adjusted down, as the front
nozzles will hold the stack in position. Heavier and/or wider stock may require the feed
finger to be lowered to the point that it will hold back the second sheet but allow the
first sheet to pass.
Feed Finger all the way
up, and face lined up with beginning
of slope on vacuum manifold
3.2 Side Rail Set Up
• Mark a sheet in the center of leading edge
• Position the center of the sheet at the center of the vacuum feed belt
• Move the operator-side guide up to the edge of the paper
• Remove the sheet and, using the register holes in the feed table, align the operator-
side guide (inside edge) to the nearest holes for square and secure it on both ends
• Slide a single sheet up to the front of the side guide
• Bring the non- operator side guide snug up to the single sheet and secure the front of the
guide
• Place a 1-inch lift of paper in the rear of the feeder and snug the non-operator side guide
to the lift and secure on rear end. Double check that the single sheet slides back and
forth easily, but not side to side
• Remove the single sheet and slide the lift up to the feed adjuster
• Position the back stop at the rear of, and under the lift of paper
Page 8