Printronix PrintCart - Manual (Page 46)

46
Chapter 5 Hand Grip Replacement
Hand Grip Replacement
1. Remove the hand grips by placing your fingertips on the innermost
shoulder of the grip and pulling it straight off the steel handle.
If that is too difficult, insert a small flat screwdriver blade under the grip to
loosen it and stretch the grip away from the steel handle.
2. Twist the grip while pulling it off.
3. Install the new grip onto the handle by pushing only on the end of the grip.
If it is too tight, apply a small amount of a mild solution of soap and water.
Replacement grips can be found from local sources and need to fit a 1 inch
outer diameter tube. Some are specified in the spare parts section
(see “Spare Parts” on page 51).