Printronix PrintCart - Manual (Page 7)

7
1
Quick Start And Setup
Quick Start
Unpacking
WARNING Dismounting the cart from the pallet requires strength. Two people is
recommended for the task.
1. Place the pallet on a flat, level surface, leaving enough room to roll the
PrintCart off the pallet.
2. Remove the two cardboard protective shipping sleeves and set them
aside.
3. Remove the plastic wrap and shipping bag from the PrintCart.
IMPORTANT Make sure the caster brake is set.
4. Cut the bands holding the unloading ramps.
5. Lift and remove the ramps off the locating pins.
6. Reverse the ramps and engage the locating pin in the angled blocks on
the end of the pallet. See Figure 1.
Figure 1. Reversing the Ramps and Engaging the Locating Pin
Ramp
Locating Pin