Printronix PrintCart - Manual (Page 8)

8
Chapter 1 Quick Start
7. If necessary set the caster brake on the PrintCart.
8. Cut the shipping restraint tie wraps on all turnbuckles.
9. Insert a screwdriver through the center of each turnbuckle housing and
loosen the turnbuckle until you can remove the hook from the eyelet.
10. Unhook the opposite end from the PrintCart frame. See Figure 2.
Figure 2. Loosening the Turnbuckle from its Housing
11. On the opposite side of the PrintCart, repeat steps 9 and 10 to completely
disengage the shipping restraints.
12. Release the caster brake. Grasp the hand grips and pull the PrintCart
down the unload ramps to the work surface.
Figure 3. Moving the PrintCart to the Work Surface
13. Replace the unloading ramps on the pallet and store the pallet and
turnbuckles for future re-use.
Hook
Turnbuckle
Housing
Shipping
Restraint
Hand Grip
PrintCart
Ramp